Kingroon KP3S Mainboard-Diagramm

Kommentare

Mikhail - August 19, 2023

Hello!
The microSD card slot on my printer is broken. Please tell me if the “Makerbase MKS SLOT2” is suitable for connector “SD extender”. If not, could you send me the pinout for this connector?
Thank you

Mark Hamilton - Juli 3, 2023

I purchased a filament runout sensor and fitted to DET1 however when filament is loaded it senses that there is no filament present. Is it a simple config change in the firmware to >cfg_filament_det0_trigger_level 1 to invert this setting?

Oleksandr - Juni 22, 2023

Is it possible to use the port for esp32 connection in-line driver? Marlin

semyen - Juni 21, 2022

Hello, what is the in-line driver slot for? is it possible to put the tms 2209 driver there and transfer the extruder operation to this slot?

Michael White - April 21, 2022

I assume the second extruder temperature port from the left, labelled TH1, is for extruder 0 (the first or only hotend. It’s labelled for #2, as is TH2 on the left.
Thanks
Mike

Cristian Esteban Caballero Sosa - April 15, 2022

Is there a way on firmware to change E0 interface to E1 interface?

Cristian Esteban Caballero Sosa - April 15, 2022

Is there a way on firmware to change E0 interface to E1 interface?

Cristian Esteban Caballero Sosa - April 15, 2022

Is there a way on firmware to change E0 interface to E1 interface?

Cristian Esteban Caballero Sosa - April 15, 2022

Is there a way on firmware to change E0 interface to E1 interface?

Cristian Esteban Caballero Sosa - April 15, 2022

Is there a way on firmware to change E0 interface to E1 interface?