Kingroon KP5L-Firmware zum Herunterladen

Every piece of firmware run on this machine just prints a while then runs and does something strange and tries to pick up where it was and print again. Complete trash. The hardware and display look good but not one thing more has been good. Direct Usb CONNECTIONS are even worse as it tries to do a bed centering alignment line print pattern – bed centering and a 45 degree travel till the bed has to do a belt over run and then come back to a different bed center. But it is suppose to be doing a model print. Where is the code to fix this? Something in the firmware is just so far out of wack that it is nothing but pure sabotage operations.

Hello! Installed Klipper and it works great. I had to roll back to the factory firmware, the hot block does not heat up. What could be the problem?

KP5L is trash I have replaced the original board with 2 other boards that are trash as well. I’m very disappointed with this product.

#warning "Maple build environments are deprecated. Please use a non-Maple build environment. Report issues to the Marlin Firmware project

How do I compile firmware for kp5l. Marlin 2.1.1.