Kingroon KP5M Screen Errors
Err 1: hot bed MAXTEMP
Err 2: nozzle MAXTEMP
Err 3: hot bed MINITEMP
Err 4: nozzle MINITEMP
Err 5: nozzle heating failure
Err 6: hot bed heating failure
Err 7: Thermal runaway
Check your nozzle temperature or your heatbed temperature by tapping "Preheat" button. A negative number indicates that the thermistor is in poor contact or has been damaged.
Layers Misaligned and Shift
Loosing X/Y timing belts will cause to layer shift. Fix your timing belts when it appears.
Clogged Nozzle
Heating up the nozzle, then remove the material remainings in the nozzle. Clean your nozzle or replace it with a new one.
3D Printing Model Warping
a> Set different temperature according to differnt 3D print filaments.
b> Relevel your 3D printer. Maybe the distance between the nozzle and the heatbed is too large that the first layer failed to stick on the heatbed.
c> The printing speed of the first layer is too fast. We recommend you to set the first layer speed to 20mm/s.
klipper send me this error after few minutes of begin print… Help!!!
TMC ‘stepper_y’ reports error: DRV_STATUS: 001701c3 otpw=1(OvertempWarning!) ot=1(OvertempError!) ola=1(OpenLoad_A!) olb=1(OpenLoad_B!) t120=1 cs_actual=23
Once the underlying issue is corrected, use the
“FIRMWARE_RESTART” command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
Hello, My Kingroon KP3S says Err6 and in the Hot bed temp it says -50, everytime i try to pre heat the bed or even use it stays in -50 and I dont know how to fix it, i need help, Plus i just started at 3D printing please help
Hello, My Kingroon KP3S says Err6 and in the Hot bed temp it says -50, everytime i try to pre heat the bed or even use it stays in -50 and I dont know how to fix it, i need help, Plus i just started at 3D printing please help
Hello, My Kingroon KP3S says Err6 and in the Hot bed temp it says -50, everytime i try to pre heat the bed or even use it stays in -50 and I dont know how to fix it, i need help, Plus i just started at 3D printing please help
Hello, My Kingroon KP3S says Err6 and in the Hot bed temp it says -50, everytime i try to pre heat the bed or even use it stays in -50 and I dont know how to fix it, i need help, Plus i just started at 3D printing please help