Oprogramowanie sprzętowe Kingroon KP5L do pobrania

the worst printer on the planet , and there is no one in this company to help with problems that came from the factory , the display goes off , it does not pause , temperature changes without me asking , and now it does not print anymore because it does not find the z axis , table is screwing up , warped table , etc… I bought it a month ago and I can not get my rights , I paid for rubbish

I have a big head of hair, when I turn on Kpl5 it already starts to heat up, by itself and it goes beyond 200°. I have replaced the sensor and the problem continues. Should I knit the mini board? what is the name and morelo of the plate that is attached to the left side Z axis, where can I find this plate to buy?. Thanks

ERROR FIRMWARE 2 YEARS!
DON’T DOWLOAD!!

Me pueden colaborar con el firmware original para la kingroon kp5M por favor.

Every piece of firmware run on this machine just prints a while then runs and does something strange and tries to pick up where it was and print again. Complete trash. The hardware and display look good but not one thing more has been good. Direct Usb CONNECTIONS are even worse as it tries to do a bed centering alignment line print pattern – bed centering and a 45 degree travel till the bed has to do a belt over run and then come back to a different bed center. But it is suppose to be doing a model print. Where is the code to fix this? Something in the firmware is just so far out of wack that it is nothing but pure sabotage operations.