First Print Settings on Kingroon KP5M 3D Printer

Kingroon KP5M Bed Leveling

Step 1. Click "Leveling" to adjust the distance between the nozzle and heatbed. 

Step 2. Adjust the height of the Z-axis limit switch to set the distance between the nozzle and the platform. 

Step 3. Adjust the distance between the nozzle and heatbed by the knobs in the four corners. The right distance is 01.mm -0.2mm, which could be tested with a piece of A4 paper.

Pre-heat & Filament Loading

Preheat the nozzle to 180 degree or above. Hold the extruding clamp by hand insert the filament in the filament feeder until the filament flows out from the nozzle. 

Slicer Software Settings

Step 1. We recommend you to use Cura slicer. You could get the software in the TF card in the package or download directly from the website of Cura. Install it according the the steps. 

Step 2. Find the corresponding printer brand of "Kingroon". Since Cura han't added Kingroon KP5M series 3D printers in its official recommend profiles. You could select the profile of our Kingroon KP3S, then change the print size to 230*230*230mm. 

Start Printing

Click slicer after all your settings are well done. Generate and save G-code file on your TF card. Please don't remove or insert storage card during print.