Kingroon KP3S 3.0 Firmware Download

Comentarios

KINGROON Office - enero 4, 2022

@Lars
The extruder does not work properly when the nozzle is heated to 200?

KINGROON Office - enero 4, 2022

@Christoph
Is the 103 version of the firmware, if the machine did not change the motherboard, it is not necessary to update the firmware, brush the wrong firmware, it is likely that the brush will not come back.

minedgeekble - enero 3, 2022

I just sent the video to the email you asked me to send. Please check it out.
I sent an e-mail to dldhswn0526@gmail.com to the address you requested.

Christoph - diciembre 30, 2021

@Lars there is a robin-nanao_cfg file on jour defice or post us the M501 outpput, my values are totaly fxxxxed since using this firmware

Christoph - diciembre 30, 2021

What is the correct Firmware for a KP3S110218XXX

Lars - diciembre 30, 2021

Good day,
i am a proud owner of a Kingroon KP3S. I wanted to calibrate my extruder because it doesn’t extrude by 10mm. Unfortunately I don’t know exactly which firmware is on it to set this with Ponterface (the E-Steps). I also lack the M commands to get the necessary information. Hope you can help me further. Translated with Google Translate.

Thank you very much.

Christoph - diciembre 29, 2021

Hi,

with the Flash of my F103 all drivers are now in reverse …

NoTaMu - diciembre 28, 2021

Isn’t this method accurate?
https://i.postimg.cc/FHgjPSgC/KP3-S-Firmware-Version.png

KINGROON Office - diciembre 28, 2021

@minedgeekble
Is the position of the extruder not heating up or the fan is not turning? What does the display indicate?

KINGROON Office - diciembre 28, 2021

minedgeekbleminedgeekble Can you take a video to see it? My email is supportkingroon.com