Kingroon KP5L Firmware to Download

Kingroon KP5L (half-assembled version) stock firmware to DOWNLOAD.

Kingroon KP5L (full diy version) stock firmware to DOWNLOAD. This is Marlin firmware that need you to compile. 

Artículo anterior 3D Printable Upgrades for your Kingroon KP3S [Weekly Best Share 01]
Artículo siguiente Kingroon KP3 Firmware Download

Comentarios

Juan Calle - mayo 12, 2023

Me pueden colaborar con el firmware original para la kingroon kp5M por favor.

bytlan - mayo 10, 2023

Every piece of firmware run on this machine just prints a while then runs and does something strange and tries to pick up where it was and print again. Complete trash. The hardware and display look good but not one thing more has been good. Direct Usb CONNECTIONS are even worse as it tries to do a bed centering alignment line print pattern – bed centering and a 45 degree travel till the bed has to do a belt over run and then come back to a different bed center. But it is suppose to be doing a model print. Where is the code to fix this? Something in the firmware is just so far out of wack that it is nothing but pure sabotage operations.

Igor - mayo 8, 2023

Hello! Installed Klipper and it works great. I had to roll back to the factory firmware, the hot block does not heat up. What could be the problem?

Jorge - abril 20, 2023

KP5L is trash I have replaced the original board with 2 other boards that are trash as well. I’m very disappointed with this product.

Andrey - marzo 29, 2023

#warning "Maple build environments are deprecated. Please use a non-Maple build environment. Report issues to the Marlin Firmware project

Andrey - marzo 29, 2023

How do I compile firmware for kp5l. Marlin 2.1.1.

alex - marzo 11, 2023

can you please send the good firmware the mail?

Artemy Artemy - marzo 2, 2023

Пришлите пожалуйста на почту стандартную прошивку для kp5l. В файле на этой странице ось x едет в другую сторону

Илья - febrero 5, 2023

здравствуйте! помогите решить проблему , при нажатии на паузу поднимается по оси Z вверх до упора а потом пишет нет фаила , и заменить феломент во время печати не возможно

Ярослав - enero 25, 2023

Здравствуйте захотел обновить прошивку на своём kp5l. После обновления все иконки стали белыми. Причём все функции исправно работают. Пытался откатить прошивку назад но ничего не помогло. Помогите пожалуйста.

Deja un comentario

* Campos requeridos