Kingroon KP3 Firmware Download

  • Firmware for Kingroon KP3 (KP3-3DP180) to DOWNLOAD

Kingroon KP3 3D Printer Specification

Model Kingroon KP3-3DP180 3D printer
Print Volumn 180*180*180mm

kingroon kp3

 

  • Firmware for Kingroon KP3S 2.0 with red extruder to DOWNLOAD.

     

    Previous article Kingroon KP5L Firmware to Download
    Next article Cura Profile / Settings to Download for Kingroon KP3S

    Comments

    Paul Resch - abril 2, 2022

    Working on a mechanical problem, one bad wheel, I accidently ejected the TF card and got a ‘no files found’ after a reboot. I downloaded the new firmware and while I can print, all the graphics are wrong. I have a STM3F103 chip. It used to matter which of two or three chips you had.

    JT - marzo 30, 2022

    I too have the same problem as brett
    “The latest firmware from March 5, 2022 seems to have reversed the X,Y, and Z direction of motion on my KP3-3DP180. The button on the screen that used to go up goes down. The print head goes up instead of down to the sensor that senses the bottom of the tray. Maybe a * -1 crept in to the source code somewhere. The little touch sensors to stop the motion never trigger as a result.”

    Not sure how to fix it.

    Les - marzo 7, 2022

    Too much going wrong since firmware upgrade. Too much time researching and trying to fix. Will be sending back. Not worth it.

    Brett - marzo 6, 2022

    The latest firmware from March 5, 2022 seems to have reversed the X,Y, and Z direction of motion on my KP3-3DP180. The button on the screen that used to go up goes down. The print head goes up instead of down to the sensor that senses the bottom of the tray. Maybe a * -1 crept in to the source code somewhere. The little touch sensors to stop the motion never trigger as a result.

    Les - marzo 6, 2022

    latest firmware totally messed me up. Display screen GUI distorted.

    Kingroon 3D Official - febrero 22, 2022

    @Sergei
    Which mainboard did your printer use?

    Kingroon 3D Official - febrero 22, 2022

    @Justin
    Did you want to use the firmware to upgrade the extruder? or others?

    Kingroon 3D Official - febrero 22, 2022

    @Darko
    Our KP3 only have one motherboard, so the firmware is fit for all KP3

    Darko Pop - febrero 20, 2022

    Is this firmware for all motherboards?

    Sergei Konstantinov - febrero 14, 2022

    Dear Kingroon.

    I am very satisfied with my KP3S.
    I have recieved Titan extruder for upgrade and installed it on my KP3S
    Can I have Official firmware for KP3S with Titan?

    Best regards

    Leave a comment

    * Required fields