Kingroon KP3S Pro Stock Firmware to Download

Comentarios

bob - noviembre 24, 2022

Firmware turned my icons into white squares on the kp3s pro. Please fix firmware on website, it’s bad firmware you have for download.

bob - noviembre 15, 2022

PLEASE UPDATE THE FIRMWARE, IT HAS A BUG AND TURNS THE LCD SCREEN WHITE! HELLO???

Igor - noviembre 12, 2022

I agree with Bob’s post. There is such a problem in the firmware. After some printing time, the screen turns white, but printing does not stop.

bob - noviembre 12, 2022

This firmware has a bug. It will turn your screen white. Admin, please fix the problem and re-upload a good flash of the firmware to the website.

Igor - noviembre 11, 2022

????

Igor - noviembre 8, 2022

Where can I download? There is only stock firmware.

yanggaoji - noviembre 7, 2022

download

Igor - noviembre 6, 2022

Hello. When will 3DTouch the firmware with z probe offset wizard for KP3S Pro

Andrei - noviembre 1, 2022

Hello.
I would like to know if there will be an updated firmware for Kingroon KP3S Pro with Linear Advance enabled in the near future? In the latest version of Marlin 2, a bug was fixed for the TMC2225 drivers and it became possible to enable a mode “Linear Advance” that improves printing accuracy.

Hunk - octubre 25, 2022

I found that the temperature’s problem is not caused by the firmware. And it’s caused by the spliter software.

So it’s all OK.